2-Seal™ Thermal Wing Nut Anchor


DOCUMENTS & DOWNLOADS

Submittal Sheets

pdf

Does your thermal anchor pass the test? READ THE REPORT!

The Thermal 2-Seal™ Wing Nut Anchor is an innovative single screw veneer tie for metal stud construction, it features a dual-diameter barrel with factory-installed EPDM washers to seal both the face of the insulation and the air/vapor barrier, and unique Thermal Wings that are designed to decrease thermal transfer through rigid insulation.

  • The projecting Thermal Wings:
    • Are made from steel encapsulated in plastic to create a thermal break, the plastic is highly flame resistant
    • Accept a 2X-HOOK™ or Seismic 2X-HOOK™ and spin to easily orient pintles/hooks parallel to masonry joints
    • Up to 1/2” of inward adjustability to account for variations in wall thickness
  • H&B's Stainless Steel barrels have one-third the thermal conductivity of carbon steel barrels and one-seventh the thermal conductivity of the zinc barrels of our competitors products (refer to chart below)
    Metal Type
    Thermal Conductivity
    (W/cm K)
    Stainless Steel (Type 304)
    0.15
    AISI-SAE 1020 (Plain Carbon Steel)
    0.52
    Zinc (Commercial)
    1.1
    References:
    • ASM Metals Reference Book, Second Edition, American Society for Metals, Metals Park, OH, 1983.
    • Lynch, C. T., CRC Practical Handbook of Materials Science, CRC Press, Boca Raton, FL, 1989.
    • Shackelford, J. F., and Alexander, W., CRC Materials Science and Engineering Handbook, CRC Press, Boca Raton, FL, 1991.
  • Made with a 5/16” hex head, install with a standard hex socket
  • Adaptable for seismic zones with the simple addition of 9 gauge or 3/16" continuous wire and a 2X-HOOK™ Seismic Pintle (SH)

The compressed leg 2X-HOOK™ has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!

  • NOTE: 2X-HOOK™ CAN BE INSTALLED WITH LEGS POINTING UP OR DOWN.
  • The embedded portion of the 2X-Hook is 3/16”DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire.
  • 2X-Hook: U.S. Pat. No. 8,613,175 Test results available upon request.

AVAILABLE FINISHES:

  • Type 304 Stainless Steel Barrel with Polymer Coated Screw

DIMENSIONS:

  • Available in 5/8", 1", 1-1/2", 2", 2-1/2", 3", 3-1/2", 4", 4-1/2", 5", 5-1/2", 6", and 6-1/2" sizes (Equal to thickness of wallboard and/or insulation)

NOTES:

CONSTRUCTION CONDITIONS


• STANDARD
• SEISMIC

BACKUP TYPE/CONDITIONS


• Metal Stud Backup

AVAILABLE FINISHES


• Stainless Steel - Type 304
• Thermal Coating

ANCHOR TYPE


• BARREL SCREW
• WINGNUT

ANCHOR FEATURES


• Seals Insulation & Air Barrier
• Secures Insulation to Backup
• Creates Thermal Break