PTA SERIES ANCHORS - PTA 420 HS

The PTA 420 Partition Top Anchor has been developed to provide lateral shear resistance at the upper limit of masonry walls.

• They permit vertical deflection of the slab above, without transferring compressive loads to the masonry wall below.
• PTA Tube with expansion filler is placed over rod (#3 rebar) anchor, which has been attached to concrete or steel by any of the methods illustrated.
• The vertical joint is then filled with mortar, fully surrounding tube.
• Clear butyrate tubes with compressible polyethylene filler isolate the anchor from the surrounding mortar, allowing the anchor to slide vertically.
• PTA Series Anchors are suitable for construction using steel or concrete.

DIMENSIONS/GAUGES:

• Rod is #3 rebar
• Straps are 3/16" plate
• Other diameters and gauges available, including heavy-duty styles for hurricane velocity wind loads
• Contact our technical department for further information.

AVAILABLE FINISHES:

• Hot Dip Galvanized
• Stainless Steel

NOTE:

• Special high-load designs can be manufactured on a special order basis contact our technical department for information.