HB-5213 Adjustable Veneer Anchor


DOCUMENTS & DOWNLOADS

Submittal Sheets

Try the new ProWall Tool and generate submittal packages 10 TIMES faster!

Safety Data Sheets (SDS)

LEED

Due to unprecedented supply chain disruptions we are providing LEED details on an ad hoc basis. Please contact your local H&B Representative for LEED information.

CAD

Register or login to access CAD files.
pdf

HB-5213 adjustable veneer anchor designed to anchor masonry to concrete, block or brick, accommodating rigid insulation up to 6 inches (75mm) thick.

The compressed leg 2X-HOOK™ has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!

  • Furnished with one 7/16”Ø hole for use with 523 Brass Expansion Bolt.
  • The eyelets allow 2X-HOOK™ (pintle) insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances.
  • For metal stud construction, use the HB-213.
  • NOTE: 2X-HOOK™ CAN BE INSTALLED WITH LEGS POINTING UP OR DOWN.
  • The embedded portion of the 2X-Hook is 3/16”DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire.
  • 2X-Hook: U.S. Pat. No. 8,613,175 Test results available upon request.

GAUGES:

  • 14 ga. or 12 ga. thick

AVAILABLE FINISHES:

  • Hot-Dip Galvanized
  • Stainless Steel (Type 304 or Type 316)

DIMENSIONS:

  • 2X-HOOK™ lengths: 3” (300H-2X), 4” (400H-2X), 5” (500H-2X), 6” (600H-2X), and 7” (700H-2X)

NOTES:

  • H&B recommends 16" x 16" spacing
  • Legs fabricated to accommodate up to 6" thick insulation and/or wallboard combination (state thickness when ordering)
  • Optional: HB-213 Washer to hold insulation to back-up

CONSTRUCTION CONDITIONS


• STANDARD

BACKUP TYPE/CONDITIONS


• Concrete Backup
• CMU/Masonry Backup

AVAILABLE FINISHES


• Hot Dip Galvanized
• Stainless Steel - Type 304
• Stainless Steel - Type 316

ANCHOR TYPE


• WIRE TIE & PLATE

ANCHOR FEATURES


• Secures Insulation to Backup
• Vertical Adjustability