manu-spec and spec-data logo

T1 - Termination Bar

Ask a question
T1 - Termination BarT1 - Termination Bar
Move your mouse over image or click to enlarge

T1 - Termination Bar is used at top of flashing to secure it to backup and is compatible with all H&B membrane and copper-laminate flashings.

DIMENSIONS:

  • 1/8” x 1” x 8’ long
  • 1/4” holes spaced 8” on center

AVAILABLE FINISHES:

  • Type 304 stainless steel
  • Aluminum
  • Plastic

NOTE:

  • Alternate styles available in T2 Aluminum and T2
  • Available with optional Foam-Tite Seal™ to aid in inhibiting moisture infiltration
    • This factory-installed foam strip helps seal small voids occurring between the termination bar and any irregular surfaces of the substrate, while offering added protection against water penetration due to deterioration of the sealant
    • FTS - Foam-Tite Seal™ : specify T2-FTS when ordering
    • Only Stainless Steel and Aluminum versions of the T1 Termination Bar are acceptable for the ENVIRO-BARRIER System Warranty.
  • U.S. Pats. No. 6,945,000
    Patents Pending

Copyright © 2014 Hohmann & Barnard, Inc

30 Rasons Court :: Hauppauge, NY 11788-0270
Telephone: (631) 234-0600 :: FAX: (631) 234-0683 :: Contact Us
Privacy Policy | Safe Harbor | Terms of Use | Site Map