PTA Series Anchors - PTA 422

Ask a question
PTA Series Anchors - PTA 422PTA Series Anchors - PTA 422
Move your mouse over image or click to enlarge


PTA 422 Partition Top Anchors have been developed to provide lateral shear resistance at the upper limit of masonry walls.

  • They permit vertical deflection of the slab above, without transferring compressive loads to the masonry wall below.
  • PTA Tube is not required with the PTA-422. H&B's NS Neoprene Sponge placed between the concrete block and the PTA-422 allows vertical expansion and contraction.
  • PTA Series Anchorsare suitable for construction using steel or concrete.

DIMENSIONS/GAUGES:

  • 12 ga. thick
  • Available for 4-12 block
  • Holes 7/16" dia.

AVAILABLE FINISHES:

  • Pre-Galvanized, Hot Dip Galvanized or Stainless Steel

NOTE:

  • H&B provides engineering calculations for all standard PTA Series Partition Top Anchors upon request. Special high-load designs can be manufactured on a special order basis. Contact our technical department for information

Copyright © 2014 Hohmann & Barnard, Inc

30 Rasons Court :: Hauppauge, NY 11788-0270
Telephone: (631) 234-0600 :: FAX: (631) 234-0683 :: Contact Us
Privacy Policy | Safe Harbor | Terms of Use | Site Map