HB-213 ADJUSTABLE VENEER ANCHOR

Product Image
HB-213 Adjustable Veneer Anchor shown with 2X-HOOK
HB-213 Metal Stud Assembly
Product Image
HB-213 Adjustable Veneer Anchor shown with 2X-HOOK
HB-213 Adjustable Veneer Anchor shown with 2X-HOOK
HB-213 Metal Stud Assembly
Product Image
DOCUMENTS & DOWNLOADS
Submittal SheetsSubmittal SheetsClick on the text link below to download

Submital SheetsPDF Downloads

SafetydataSafetydataClick on the text link below to download

Safety Data SheetsPDF Downloads

Submittal SheetsSubmittal SheetsClick on the text link below to download

LEEDPDF Downloads

CadCadClick on the text link below to download

CADZIP Downloads

GearGear
Submittal Package Generator
MegaphoneMegaphone
Ask us a question about this product
PRODUCT DESCRIPTION

The HB-213 is an adjustable veneer anchor for metal stud and wood stud construction.

The compressed leg 2X-HOOK™ has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!

  • The L-shaped plate section has numerous ribs for added strength and 9/32" holes for connecting screws.
  • The eyelets allow 2X-HOOK™ (pintle) insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances.
  • For concrete, CMU or brick backup, use the HB-5213.
  • Formerly called the HB-200/DA-213 or HB-200 Adjustable Veneer Anchor
  • NOTE: 2X-HOOK™ CAN BE INSTALLED WITH LEGS POINTING UP OR DOWN.
  • The embedded portion of the 2X-Hook is 3/16”DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire.
  • 2X-HOOK™: U.S. Pat. No. 8,613,175 Test results available upon request.

GAUGES:

  • 14 ga. or 12 ga. thick

AVAILABLE FINISHES:

  • Hot-dipped Galvanized
  • Stainless Steel (Type 304 or Type 316)

SEISIMIC OPTIONS:

NOTES:

  • H&B recommends 16" x 16" spacing
  • Legs fabricated to accommodate up to 6" thick insulation and/or wallboard combination (state thickness when ordering)
  • Also available:HB-200-X : features three pronged punch-outs that project from the back of the anchor. The prongs prevent positive wind-loads from crushing the wallboard by transferring these loads to the back of the stud.
  • Optional: HB-213 Washer to hold insulation to back-up
Vertical Adjustability
1 1/4"
Finishes/Materials
Hot-Dip GalvanizedType 304 - Stainless SteelType 316 - Stainless Steel (Special Order)
Hole Diameter
9/32"Ø (STANDARD)
Thickness/Gauge
12 gauge14 gauge
Backup Type
BrickConcreteCMUMetal StudWood Stud
Sizes
0"1"1 1/2"2"2 1/2"3"3 1/2"4"4 1/2"5"5 1/2"6"
Minimum Air Space Requirement
3/4"
This site uses cookies to improve your experience. By clicking, you agree to our Privacy Policy.