Tie-HVR-295V Anchor System - Ladder Type

pdf

Ladder Type rubble (or ashlar) stone anchoring system for cavity or insulated walls.

  • In the Tie-HVR-295V, the backup is reinforced with a ladder type reinforcement with projecting boxes and a factory-welded restraint bar
  • The mason then places the vertical rod into the projecting boxes as shown (after inserting it into the hole of the flexible wire tie)
  • Rubble stone can then be tied easily to the backup using these flexible ties wherever the veneer mortar joint may lie.
  • Ideal for when horizontal mortar joints do not align, and a large amount of vertical adjustability is required.
  • Tie-HVR-295V Anchor System - Ladder Type

DIMENSIONS/GAUGES:

  • Backup Ladder available with any combination of 9 ga. or 3/16" dia. Side and Cross Rods.
  • Vertical Hook is 5/16" or 3/8" diameter. Specify when ordering. (Engineering calculations available upon request.)
  • Vee Ties are standard 3/16" dia. x length to suit.

AVAILABLE FINISHES:

  • Hot Dip Galvanized
  • Stainless Steel

NOTES:

CONSTRUCTION CONDITIONS


• STANDARD

BACKUP TYPE/CONDITIONS


• Cavity/Insulated CMU Backup
• CMU/Masonry Backup

AVAILABLE FINISHES


• Hot Dip Galvanized
• Stainless Steel - Type 304
• Stainless Steel - Type 316

JOINT REINFORCEMENT TYPE


• LADDER

DIMENSIONS/GAUGES


• Flexible Wire Ties Standard 3/16" Ø x length to suit
• Vertical J-Hook 3/8”Ø, 7/16”Ø, or 1/2”Ø