2X-SH COMPRESSED LEG SEISMIC HOOK

2X-SH Compressed Leg SEISMIC HOOK
2X-SH Compressed Leg SEISMIC HOOK
2X-SH Compressed Leg SEISMIC HOOK
2X-SH Compressed Leg SEISMIC HOOK
DOCUMENTS & DOWNLOADS
Submittal SheetsSubmittal SheetsClick on the text link below to download

Submital SheetsPDF Downloads

SafetydataSafetydataClick on the text link below to download

Safety Data SheetsPDF Downloads

GearGear
Submittal Package Generator
MegaphoneMegaphone
Ask us a question about this product
PRODUCT DESCRIPTION

Hohmann & Barnard's SH-Seismic Hook:

  • This hook is "swaged" (indented) in two places to accommodate either a 9 gauge or 3/16" continuous wire
  • A channel is formed that braces the continuous wire and holds it in place
  • Suitable for standard 3/8" joints
  • Rectangular hook/pintle acts as a vertically adjustable anchor to bond exterior masonry, while restraining in and out movement.
  • Design of hook/pintle serves to mechanically secure insulation to masonry backup.
  • Features the same compressed leg design as the 2X-HOOK™ and has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!

AVAILABLE FINISHES:

  • Hot Dip Galvanized
  • Stainless Steel
  • NOTE: H&B Recommends Stainless Steel for maximum protection against corrosion

NOTE:

  • U.S. Pat. No. 6,789,365, 7,325,366 & 8,096,090
  • Specify "SH" Seismic Hook with: 170 Eye-Wire, 270 Eye-Wire, HB-213, and 2-SEAL Thermal Wing Nuts
Lengths
3"4"5"6"7"CUSTOM
Wire Size
3/16" Ø
Finishes/Materials
Hot-Dip GalvanizedType 304 - Stainless SteelType 316 - Stainless Steel (Special Order)
This site uses cookies to improve your experience. By clicking, you agree to our Privacy Policy.