Seismic Clip 300C w/HB-213


The 300C is a seismic clip welded to a hook (pintle) and designed for use with the HB-213 adjustable veneer anchor. That features a L-shaped plate section with numerous ribs for added strength and 9/32" holes for connecting screws. The eyelets allow pintle/hook insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances.

  • The 300C clips are welded to ties to accept either 9 gauge or 3/16" continuous wire.
  • Continuous wire is beneficial for seismic zones or to provide additional protection against problems arising from thermal expansion and contraction. The continuous wire also allows for a more uniform distribution of lateral forces.


  • 14 ga. or 12 ga. thick


  • Hot Dip Galvanized
  • Stainless Steel


  • Hook (pintle) lengths: 3", 4", or 4 3/4"
  • Legs fabricated to accommodate up to 6" thick insulation and/or wallboard combination (state thickness when ordering)


  • HB-213 replaced the HB-200
  • H&B recommends 16" x 16" spacing
  • Optional: HB-213 Washer to hold insulation to back-up